Equipment | Specs and Tech info

Misc Bits and Pieces

Now all the busbars are installed I can finally fire up the Batrium. Using the Testmon I tested my wiring loom. All good.

Testing the wiring loom

I also created a small precharge resistor pack so I can precharge the caps in the Victron Multiplus II inverter.

I covered the resistors in heatshrink after taking this photo.

I now have a bit of a wait before anything new can occur. My sparky is not available till the 14th December – and we will be completely rewiring my meterbox. Until this is complete I cannot connect the Multiplus II.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *